Entrada de blog

Tired of pulling into Cars & Coffee in the same silver Model Y as five other drivers? Your Tesla deserves a personality as bold as the engineering under the hood. The Tesla Model Y Snake American Flag Claw Scratch Decal Kit turns a clean canvas into a head-turning statement — a coiled cobra tearing through a distressed American flag, claw marks raked down the door panels. Patriotic. Aggressive. Impossible to ignore.

What Is the Tesla Model Y Snake American Flag Claw Scratch Decal Kit?

This is a precision-cut, vehicle-specific vinyl decal kit designed exclusively for the Tesla Model Y. Each kit ships as a mirrored pair — one stripe for the driver side, one for the passenger side — engineered to follow the Model Y's exact body lines from the front fender into the rear door panel. No guesswork. No trimming. No awkward gaps where the artwork drifts off the sheet metal.

The design itself is a layered, high-detail graphic: a fanged cobra coiled mid-strike, ripping through a weathered American flag, with three deep claw scratches dragged across the panel. It reads as one cohesive piece of artwork on the car, not a sticker-pack mashup. Because every cut is mapped to Tesla Model Y dimensions, the install lays flat across the door creases and shutlines for a factory-grade finish.

Printed on premium cast vinyl with UV-protective, weather-resistant lamination, this kit is built to survive daily driving, sun, rain, and car washes — not peel off in a season.

Key Benefits

• Custom-fit for the Tesla Model Y — contoured to door panels, fenders, and body lines for a seamless OEM-style appearance.
• Premium cast vinyl construction — conforms to curves, resists shrinking, and outlasts cheap calendered stickers.
• UV & weather resistant — colors stay sharp through summer sun, winter salt, and routine washes.
• Mirrored driver/passenger pair — symmetrical look on both sides, no DIY layout required.
• Multiple color options available — pick the shade that complements your Model Y's paint.
• Removable without damage — when applied to factory paint or PPF, it lifts cleanly without harming the finish.

Why Your Tesla Model Y Deserves This Protection

Tesla's factory paint is famously thin. Owners across every Model Y trim — from base Long Range to Performance — report rock chips on the front fenders, swirl marks from automated car washes, and UV fade on horizontal panels after a couple of summers. The flat door panels where this decal sits are especially vulnerable to door dings, parking-lot scuffs, and grit kicked up from the road. A quality vinyl graphic doesn't just style the car — it adds a sacrificial layer between the elements and your clearcoat.

If you want maximum coverage, pair the decal with serious paint protection. Browse our full PPF Kits collection for clear bra options that defend the high-impact zones, or check out all vehicle decals to keep building a look that's unmistakably yours.

What's Included & Installation

Each kit ships with two precision-cut vinyl stripes — one for the driver side, one for the passenger side — plus step-by-step installation instructions. You'll want a clean microfiber towel, isopropyl alcohol (70%+), a squeegee or hard card, and ideally a heat gun or hair dryer to help the vinyl conform around tight curves.

Installation process in short: wash and degrease the panel, dry-fit and tape the decal in position, hinge it with masking tape, peel the backing, and squeegee from the center outward to push out air. Most DIY installs take 45–90 minutes per side once you're set up.

Not a DIY person? Any reputable local vinyl or wrap shop can install this kit in under two hours — just bring them the kit and the instructions.

Complete Your Build

Browse our full collection: