Entrada de blog

Your GR86 or BRZ already turns heads — that low-slung fastback profile, the boxer rumble, the purist sports car DNA. But factory styling can feel a little restrained when you pull up next to track-prepped builds at cars & coffee. Want to add motorsport-grade attitude without committing to a full wrap or paint job? A precision-cut two-tone checkered rocker stripe is the cleanest, most reversible way to transform your car's stance overnight.

What Are the GR86 / BRZ Two-Tone Checkered Rocker Stripe Decals?

This is a vehicle-specific, die-cut vinyl stripe kit engineered exclusively for the second-generation Toyota GR86 and Subaru BRZ (2022–present). It's not a universal roll of vinyl trimmed to fit — every contour, taper, and fade pattern was digitised from the actual ZN8/ZD8 chassis so the graphic flows naturally from the front fender arch through the rocker panel and into the rear quarter.

The design itself is a two-tone checkered racing stripe with a dynamic dissolve pattern, inspired by GT4 livery work and Gazoo Racing motorsport graphics. It sits on the lower body — the area most likely to catch rock chips and road grime — so it actually adds a small layer of cosmetic coverage while delivering serious visual impact.

Because the kit is pre-cut for this exact platform, you don't waste time measuring, masking, or guessing. You peel, position, and squeegee.

Key Benefits

• Exact fitment for GR86 & BRZ (2022+): Patterned to the 2nd-gen rocker geometry — no trimming, no overhang, no compromise.
• Premium cast vinyl construction: Conforms to body curves, lays flat without lifting, and rated for 5–7 years of outdoor durability.
• Two-tone checkered fade design: A dynamic dissolve pattern that transitions cleanly along the door — more aggressive than a flat stripe, more refined than full graphics.
• Air-release adhesive: Channels built into the adhesive layer push out bubbles for a glass-smooth, professional finish even for first-time installers.
• UV, water, and scratch resistant: Wash it, wax it, drive it through summer heat or winter salt — colours hold and edges stay sealed.
• Removable without paint damage: Unlike repaints, vinyl peels cleanly when heated. Your factory finish — and resale value — stays intact.

Why Your GR86 or BRZ Deserves This Upgrade

The GR86 and BRZ ship with thin factory clear coat — par for the course on affordable sports cars — and the rocker area takes the worst of it. Every highway mile pelts the lower body with gravel, salt spray, and tar. Add a few canyon runs or autocross weekends and those rockers start collecting chips and swirls long before the rest of the car shows wear. A vinyl stripe placed over this zone gives a sacrificial visual layer that absorbs minor abrasion and keeps your paint hidden underneath.

If you want full coverage protection underneath your graphics, pair this stripe with a clear bra setup — browse our full range of PPF kits for pre-cut paint protection film tailored to high-impact zones. And if you're building out a complete cosmetic refresh, our vehicle decal collection has matching accents to tie the whole build together.

What's Included & Installation

Every kit ships with two precision-cut vinyl stripes (one driver side, one passenger side), a free squeegee install kit, and step-by-step application instructions. Nothing extra to buy.

Installation is straightforward: wash and degrease the rocker panel thoroughly with isopropyl alcohol, mix a few drops of dish soap with water in a spray bottle for the wet-install method, position the decal, then squeegee firmly from the centre outward to push out any solution and air pockets. Let it cure 24 hours before washing. Most DIYers finish both sides in under two hours.

Not confident installing yourself? Any reputable wrap or detail shop can mount these in under an hour — typically for $75–$150 per side.

Complete Your Build

Browse our full collection: