Door and Mirror Guard Strips: Finding the Right Contact Point
A small guard strip is useful only if it sits where contact is likely. Before placing one on a door or mirror, check the shape of the panel and how the part moves. Our four-piece door and mirror guard set provides four individual strips for selected smooth surfaces.

Start with the contact point
Open the door carefully in your usual parking space without letting it strike the wall or another vehicle. Identify which part projects farthest. A strip placed well above or below that point may never touch first. On a mirror, inspect both the parked and folded positions before choosing a location.
Measure the whole adhesive footprint
Each strip in this set measures approximately 5.83 inches long, 0.55 inch wide and 0.28 inch thick. Make a paper template of the length and width and hold it against the intended position. Look for a smooth area that supports the full backing. Sharp curves, grainy plastic and narrow ridges can leave an end unsupported.
Check movement and surface condition
With the backing still attached, test door closing clearance and mirror folding clearance. Keep the guard away from cameras, sensors, lights, rubber seals and drainage openings. Do not apply over loose paint, corrosion or peeling clear coat. A guard is not a repair for damaged paintwork.
Choose a finish and prepare carefully
Black creates a visible accent, white suits lighter trim, and transparent keeps more of the original color visible. Clear material can still show its outline. Wash and dry the area, remove wax or polish residue with a product safe for the finish, and follow the adhesive instructions provided with the kit. Press the entire strip evenly rather than only its center.
Know the limits
These are small contact buffers, not a guarantee against dents or scratches. Check adhesion regularly and stop using any piece that lifts. Compare the measurements and color options on the door and mirror guard product page before ordering.

