Long Door Side Skirt Stripe Decal for Acura RDX, MDX, TLX & ILX | Sport Vinyl 2-Piece Kit
Tired of your Acura looking like every other one in the parking lot? Factory styling on the RDX, MDX, TLX, and ILX is sharp — but it's also conservative. If you want a clean, aggressive sport profile without committing to a body kit or repaint, a long door side skirt stripe is the fastest, most affordable upgrade you can make. This 2-piece kit runs the full length of the door skirt to highlight your Acura's body lines and give it that finished, dealer-show-floor look.
Order Now →
What Is the Long Door Side Skirt Stripe Decal for Acura?
This is a precision-cut, long-format vinyl stripe kit designed specifically for the lower door skirt area of Acura RDX (YD2/YD3), MDX, TLX VTEC, and ILX models. Unlike short accent decals that float in the middle of a panel, this stripe spans the entire skirt — front door to rear door — giving your Acura a continuous, motorsport-inspired side profile.
Each stripe is made from durable PVC vinyl with a flexible, conformable backing that wraps gently around body contours and curves. It's a color-change graphic, not a paint protection film, so its purpose is purely cosmetic — but it also acts as a sacrificial layer against minor scuffs, parking lot rash, and door-edge contact along the lower body.
Because the kit is fitment-matched to Acura's specific door dimensions, you don't have to trim guess-work or align hand-measured lines. The shape, taper, and length are already dialed in.
Key Benefits
- Vehicle-specific fitment — designed for Acura RDX YD2/YD3, MDX, TLX VTEC, and ILX door skirts
- Long-format design — spans the full length of both doors for a seamless sport stance
- UV-resistant PVC vinyl — won't fade, yellow, or crack under sun exposure
- Flexible & conformable — wraps body lines and minor curves without lifting
- DIY-friendly install — peel, position, squeegee. No special tools required
- Removable — peels off cleanly when you're ready for a new look or trade-in
Why Your Acura Deserves This Protection
The lower door skirts on the RDX, MDX, TLX, and ILX sit right in the splash zone. Road salt, gravel kicked up by your own tires, runoff from car washes, and stray shopping carts all attack this exact panel. Acura's factory clearcoat is good, but it isn't invincible — UV exposure dulls the finish over time, and rock chips along the lower body line are one of the first things detailers flag at resale. A vinyl stripe along this area adds an extra layer of visual interest while quietly shielding the paint underneath.
If you're already investing in your car's appearance, consider rounding out the build with full-surface protection. You can browse our full PPF kit collection for clear bra options on hoods, mirrors, and bumpers, or check out our best sellers to see what other Acura owners are running.
What's Included & Installation
Your kit ships with 2 pre-cut vinyl stripes — one for the driver side, one for the passenger side. Installation is straightforward:
- Wash and degrease the door skirt area thoroughly
- Dry-fit the stripe to confirm placement
- Peel the backing slowly and apply from one end to the other
- Use a squeegee or credit card wrapped in microfiber to push out air bubbles
- Heat gently with a hair dryer to help the vinyl conform on curved sections
Most owners knock this install out in under 30 minutes per side. If you'd rather not DIY, any local wrap or detail shop can apply these in well under an hour.
Complete Your Build
Got a Super Duty in the driveway too? Same sport stripe upgrade, sized for full-size truck doors.
Order Here →